Workholding Technology - Support elements Support element with thread and base flange plate

Hydrokomp

Brand

Hydrokomp

Category

Workholding Technology

Sub Categoey

Support elements

Download

With these support elements, a spring presses the support bolt against the workpiece with slight pressure. The spring force can be adjusted using the integrated adjusting screw.

With these support elements, a spring presses the support bolt against the workpiece with slight pressure. The spring force can be adjusted using the integrated adjusting screw. Care must be taken to ensure that the workpiece is not lifted by the spring force during operation. Pressure screws (data sheet 1000-1) can be screwed into the internal thread of the support bolt for height compensation. The pressure oil is supplied either via a G1/4 threaded connection on the side or an O-ring flange connection in the base plate. The hydraulic clamping can be combined with the hydraulic clamping of the workpiece or carried out separately.

- Recommended minimum pressure: 100 bar
- Max. Support force: 60 kN at 500 bar
- Setting force: 40 N - 100 N, depending on stroke
- Basic position: extended
- Retract: against spring force

Safety instructions:
Lateral forces cannot be absorbed with support elements. If there is a risk of liquid penetrating the support element during machining, a ventilation line must be connected. The threaded hole of the support bolt must be protected from contamination with a sealing plug or screw-in element. Screw-in elements with a large mass can affect the function of the support element.

Special features:

  • Wide range of installation options
  • Internal piston thread for screwing in spacer elements, e.g. pressure screws
  • Clamping possible separately or combined with clamping process
  • Spring force adjustable via adjusting screw
  • Standard elements and special variants available
Operating pressure:pmax. 500 bar
Operating principle:Basic position extended, retract against spring force
Support bolt:
Ø 32 mm, stroke 16 mm or
Ø 40 mm, stroke 18 mm
Minimum pressure:Recommendation 100 bar
Support force:Maximum 60 kN at 500 bar
Setting force

depending on stroke 40 N
up to 100 N

Oil connection:Thread G1/4 or O-ring flange
Wiper:

Soft wiper and metal wiper

image_not_found

Workholding Technology

Rotary linear clamp Hydraulic

Hydraulic double-acting, pmax. 250 bar, pneum. query clamped and/or unclamped (also simultaneously!) During the clamping process, the rotary linear clamp first rotates the clamping arm and then switches to a linear movement. This means there are no lateral forces at the clamping point and workpiece tolerances are compensated for by the linear stroke.

LEARN MORE
image_not_found

Workholding Technology

Support elements, screw-in

Support elements, screw-in Contact by spring, actuation with hydraulics, pmax. 500 bar

LEARN MORE