Workholding Technology - Swing clamp cylinder Swing clamps compact (B)

Hydrokomp

Brand

Sub Categoey

Swing clamp cylinder

Download

VIEW

These swing clamp cylinders work single-acting with spring return or double-acting hydraulically. Depending on the version, G1/8 threaded connection or O-ring flange connection can be used for the pressure oil supply.

If the permissible volume flow is exceeded, a throttle check valve must be installed in between. When installing the clamping arm, it must be held in place to prevent damage to the ball guide.

The clamping movement is initiated with a superimposed swivel and stroke movement. This is followed by a linear clamping stroke. Variants with swivel angles of 0°, 45°, 60° and 90° are available. The clamping force depends on the clamping arm length. In addition to the standard clamping arm, special clamping arms can be fitted. The max. operating pressure of 350 bar only applies to a max. clamp length of 26 mm.

Operating pressure:	pmin. 25 bar - pmax. 350 bar
Mode of operation:	single-acting or double-acting
Swivel angle:	0°, 45°, 60° and 90°
Design:	B (bottom flange)
Piston Ø	14 mm
Clamping stroke:	single-acting 6 mm, double-acting 8 mm
Mounting:	Cone mount 1:10
Overload protection:	Without
Position control:	without
Oil connection:	G1/8 thread or O-ring flange