Low-Block Clamping Cylinder

Low-Block Clamping Cylinder

Info:

The design means that a horizontal (Fh) and a vertical (Fv) force component are created when the force is applied, the size of which depends on the stroke. The vertical (Fv) force component can amount to a maximum of approx. 25% of the clamping force (Fsp). This force is used to press the workpiece against the support. The horizontal force (Fh) decreases depending on the stroke to at least 95% of the initial force. Alternatively, the pressure oil can be supplied via a G1/4 connection thread or O-ring flange connection.

The clamping piston has an internal stroke limiter. The piston and the pressure piece are each returned to the home position by a spring after pressure relief. Care must be taken to ensure that no cutting or cooling fluids can enter the cylinder.

Special features:

  • transfers the clamping force laterally into the workpiece
  • Wide range of installation options
  • Chip protection thanks to integrated metal scraper
  • Standard cylinders and special variants available
  • Also available with pneumatic position control!
Operating pressure:pmax. 500 bar
Operating principle:single-acting with spring return
Piston Ø:16, 25 and 36 mm
Stroke8 and 10 mm
Clamping force:from 1.7 kN at 100 bar to 40 kN at 500 bar
Stroke limitation:Internal
Oil connection:G1/4 thread or O-ring flange
Seal type:NBR -10°C to +80°C
Wiper:Metal wiper